4-4
Adaptec Storage Manager Pro User’s Guide
Setting Up Remote Access for the First Time
To set up remote access, you must perform the following tasks in
sequence:
1
Register each system with the directory manager. See the steps
that follow.
2
Set up at least one global user account. See
Adding User
Accounts
on page 5-3.
Note:
All systems must have the same version of
Storage Manager Pro installed.
You can set up remote access from either of two systems on your
network:
■
System that will become the directory manager
■
System that will become a member of the new management set
Setting Up Remote Access from the Directory Manager
The instructions below assume you are setting up from the directory
manager, rather than from a member of the management set.
To set up remote access:
1
Decide which systems you want to be members of the
management set (not the directory manager) and start Storage
Manager Pro on those systems.
Write down the system name or IP address of each system you
want to be in the management set.
The Storage Manager Pro service (ASMProServer) or daemon
as well as the Storage Manager Pro software must be running
on those systems. After you install Storage Manager Pro, the
Storage Manager Pro service (ASMProServer) or daemon starts
automatically when you boot the system. See
Starting Adaptec
Storage Manager Pro
on page 1-3.
2
Start the Storage Manager Pro software on the system that you
want to be the directory manager.
See
Starting Adaptec Storage Manager Pro
on page 1-3.
Summary of Contents for 2110S - SCSI RAID Controller
Page 1: ...R Adaptec Storage Manager Pro v1 11 User s Guide...
Page 6: ......
Page 137: ...B 7 Choosing Your Array Type...