Adaptec 2100S - SCSI RAID Controller, Quick Start Manual, Page: 30 / 40

29
To install SCO, use the following steps:
1
If installing SCO UNIX 3.2V4.2 or ODT 3.0, boot the system with
disk 1. Enter the following string at the boot prompt:
defbootstr link=dpti4
If you are installing SCO UNIX 3.2V5.0.x, boot the system with the
Boot Disk. Enter the following string at the boot prompt:
defbootstr ahslink=dpti5
For SCO UNIX 3.2V5.04 or later the command is:
defbootstr link=dpti5
2
When prompted for the SCO BTLD disk (Adaptec volume), insert
disk 1 into the floppy drive.
3
Insert the N1 or Boot disk again when prompted.
4
If installing SCO 3.2V4.2 or ODT3.0, insert the N2 disk when
prompted. During the Hardware Roster, the following line should
appear:
% adapter type=dpti ha=0 id=7 channel=0, PCI
If you are installing SCO UNIX 3.2V5.0.x., during the Hardware
Roster, the following line should appear:
% adapter type=dpti ha=0 id=7, PCI
5
Continue the installation according to the SCO documentation.