20
Adaptec SCSI Card 19160 User’s Reference
SCSI Bus Interface Definitions
■
SCSI card SCSI ID
—(Default:
7
) Sets the SCSI ID for the SCSI
card. The Adaptec SCSI Card 19160 is set at
7
, which gives it
the highest priority on the SCSI bus. We recommend that you
do not change this setting.
Note:
Some operating systems will not work if the
SCSI card has an ID other than 7.
■
SCSI Parity Checking
—(Default:
Enabled
) When set to
Enabled
, verifies the accuracy of data transfer on the SCSI bus.
Leave this setting enabled unless any SCSI device connected to
the Adaptec SCSI Card 19160 does not support SCSI parity.
■
SCSI card SCSI Termination
—(Default:
Automatic
) Deter-
mines the termination setting for the SCSI card. The default
setting for both the LVD/SE and SE connectors is
Automatic
,
which allows the SCSI card to adjust the termination as needed
depending on the configuration of the connected SCSI devices.
We recommend that you do not change this setting.
Boot Device Options
■
Boot SCSI ID
—(Default:
0
) Specifies the SCSI ID of your boot
device. We recommend that you do not change the default
setting.
■
Boot LUN Number
—(Default:
0
) Specifies which LUN (Logi-
cal Unit Number) to boot from on your boot device. This set-
ting is not valid unless Multiple LUN Support is
Enabled
(see
Advanced Configuration Options
on page 22).
SCSI Device Configuration
SCSI Device Configuration options can be set individually for each
connected SCSI device.
Note:
To configure settings for a SCSI device, you must
know its SCSI ID (see
Using SCSI Disk Utilities
on page 24).
