For checkweighing in parts counting mode, use the directional buttons
⭡
or
⭣
, scroll
through to the parts counting mode,
“Count”
will be shown on the display. Press
[Tare/
↵
]
to confirm and follow the same process as outlined above.
6.7.1 Relay outputs and checkweighing
The relay outputs are open collector drivers to control an external relay. The relays will be
active when the corresponding LED is on during check-weighing. The ZERO relay output
will be on when the scale is showing the display is at Zero.
BOTH LIMITS SET
The display backlight will be
green when the weight is
between the limits
CHK bP = In / out / off
The beeper will sound when the
weight is between the limits, i.e. OK
F3 bEP = bP OtL
Beeper will sound if weight is
outside the limits.
LOW LIMIT SET
HIGH LIMIT is set to
zero
The display will be amber when
the weight is less than the Low
Limit. Above the Low Limit the
display backlight will be green,
CHK bP = In
The beeper will be off when the
weight is less than the Low Limit.
Above the Low Limit the beeper will
be on
CHK bP = Out
The beeper will be on sound when
the weight is below the Low Limit
HIGH LIMIT SET
LOW LIMIT is set to
zero
The display will show a red
backlight until High limit is
reached, then green backlight
above the High limit. Beeper will
turn on after High limit.
CHK bP = In
The beeper will be on when the
weight is less than the High Limit.
Above the High Limit the beeper will
be off.
CHK bP = Out
When set to bP OtL the indicator
alarm will turn on below the high
limit with red backlight.
The beeper will be off when the
weight is below the High Limit, on
when it is above the High limit.
BOTH LIMITS SET.
LOW
IS
SET
GREATER
THAN
HIGH
This condition is not allowed.
