Adam Equipment ADK 10, User Manual

Page: 8 / 20

3.5 VOLTAGE SELECTION
•
This balance now includes a switch to select the mains voltage.
Verify the switch is set to the correct voltage for your area.
•
The switch is located on the back panel under a small cover.
Remove the cover on the rear of the balance.
•
Remove the cover by removing the small screws on the cover. Do
not remove the screws on either side of the cover.
•
Select either 115V or 230V as required. The 115V position is for
power supplies from 110 - 120VAC and the 230V position is for
voltages of 220 – 240VAC.
RS-232 connector 110/220V Select Fuse
1/2A
On/Off
4.0 OPERATING THE BALANCE
•
To get the most from the balance, it should be warmed up for at
least one hour.
•
Don't use sharp articles (such as a pencil) to touch the keys. Use
your finger only.
•
Always place samples to be weighed on the pan gently. Never drop
them on the pan.
•
To weigh a magnetic material, a shield should be put on the pan to
keep the magnetic material 3~5cm away from the pan or you can
use the below pan weighing mode.
@Adam Equipment Company 2005
6