Adagio Water Features, Installation Instruction

Page: 7 / 12

6
G - Testing the water flow
After filling your water feature you need to prepare your water distribution unit and test the water flow.
(1) First, clean the front surface of the water distribution unit with the
provided scotch-brite pad.
Rub the pad back and forth on the entire surface
until it is noticeably cleaner and shinier. Be sure to clean over the top edge and
the bottom lip thoroughly. This removes any dust or debris that might have
accumulated since production.
DO NOT touch the copper to even the water flow over the unit, as this can
leave behind natural oils that block the water from flowing over the
distribution unit.
Mirror Prep –
If you have a mirror water feature we send a product called Mirror Prep. This is designed to help the
water flow evenly over the surface. Apply with a wet cloth and wipe it on the entire mirror surface. Make sure to apply
the prep to the outer edges of the surface. Let it dry for 2-3 minutes and then remove it with a clean wet cloth.
Water Flow:
(2) Plug in the water feature. Plug the power cord to an outlet or an extension
cord and turn your feature on. The Water Distribution Unit and Baffle should be
set to allow proper water flow. This step is for testing purposes only. It usually
takes 10-20 minutes to get the entire surface completely wet. After this time you
should be able to tell if there are any dry spots.
NOTE: The Baffle should already be firmly in place and ready to
use. But in the event that it has come loose or it needs to be
removed and replaced for adjusting or cleaning, we will discuss
how it works.
Adjusting the Baffle:
(3) Remove the white baffle from the water distribution unit. To
do so, flatten the upper set of copper tabs on the baffle, this will
allow it to roll up and out of the distribution unit. On the underside
of the baffle you will notice an additional set of copper tabs
(you
must remove the baffle completely to access these tabs). These
tabs act as small dams for the water. The water enters the
distribution unit directly in the middle of these two tabs.
(A)
Adjust the bottom copper tabs . The tabs can be adjusted in or out to
direct the water flow to each side or in the middle. These two tabs are
ONLY used to for water flow adjustments.
For Example: If you are experiencing lack of water flow in the middle
you will want to adjust these tabs down to dam more water towards the
middle of the water feature.