
Page
43
Doc : AM210-001E Release: 1.4 updated : 2015
The following screen will display the detailed information about the last verifications performed. The
following information is traced:
The instrument software version at the moment the verification was performed
Date and time of the verification
The operator name who performed the verification
The serial number of Reference Tube used for the verification in addition with its picture
Measured values for Standard 1 and Standard 2
In order to perform a new verification,
press the “Perform Verification” button,
enter your name and
follow the instructions.
Proceed in the same way as routine thickness measurement:
-
Open the DR10 test compartment cover
-
Identify the location of the tube serial number on the reference tube
-
Carefully place
reference tube
on the support, the tube serial number must be located on the
right.
-
Close the test compartment door and press OK.
-
Wait till the tube identification screen appears.
-
Use the scroll buttons to rotate the tube and see the tube serial number in the dedicated
window.
-
Type in the tube serial number corresponding to the number you read and press ENTER
CAUTION!
The test compartment door must be closed during all verification process.
-
Remove the Reference Tube from the DR10 test compartment and place it in its original
container.
Verification information will be stored in the instrument memory.
Compare the results obtained by the DR10 for both thickness standards with reference values provided
on the factory certificate. The results should be within the defined tolerance.
If the verification results are out of the acceptance tolerances, perform a DR10 base line calibration as
described in the “Baseline Calibration” section and then repeat the verification procedure.
If results are still out of acceptance, contact AD Systems service department or its local distributor.