Pairing a BT RC using the SDUs back cover “Pair” Button
Pairing a BT RC using the SDUs back cover “Pair” Button
Pairing a BT RC using the SDUs back cover “Pair” Button
Pairing a BT RC using the SDUs back cover “Pair” Button
In order to perform some of the tests below you’ll need to use the SDU’s Bluetooth Remote control.
The BT RC should be paired to one device only following the next steps.
1. Apply power to the SDU which is under test and wait till it is full booted (2 - 40 seconds)
2. (Re)Insert batteries to the BT RC. The BT RC LED is blinking to indicate it is in “discovery” mode.
Please Note: If BT RC LED stops flashing after 2 seconds it means it is ALREADY PAIRED to another device.
Please move away other SDUs which might be paired or replace the BT RC with another one.
3. While the BT RC LED is blinking press the SDUs back cover “Pair” Button till the BT RC LED stops blinking.
This should happen in 3-5 seconds.
4. To indicate if the BT RC is successfully paired to the SDU Please press the BT RC “Volume” button. The volume
indicator should appear on the bottom of the SDUs display showing volume changes.
5. Please Note: If this doesn’t seems to work… please try steps 2-4 again.
If still no success please press the SDUs back cover “Reset” button and try steps 2-4 again
.
.
Connect
Connect
Connect
Connect Passive loudspeakers
Passive loudspeakers
Passive loudspeakers
Passive loudspeakers
Two 8Ohm loudspeakers can be connected to the speaker output socket with loudspeaker cables. Observe the
polarity (+ and -) of the connections to avoid phase errors (= incorrect stereo playback).
E
E
E
External
xternal
xternal
xternal Wi
Wi
Wi
Wi----Fi antenna
Fi antenna
Fi antenna
Fi antenna
15
Connect an external Wi-Fi antenna to the antenna connector
Connect
Connect
Connect
Connect a
a
a
a 12VDC power adapter (90W max.)
12VDC power adapter (90W max.)
12VDC power adapter (90W max.)
12VDC power adapter (90W max.)
DISPLAy FRAME UNIT
TM