Page
8
of
15
Vehicle Exterior (Vehicle Lowered to Half Height)
10.
Install the Front License Plate Holder and Rear License Plate Hardware
If state regulations require the use of a front license plate, install the front license plate holder as shown.
The remaining screws are used to attach the license plates.
Vehicle Exterior (Vehicle Lowered to Ground)
11.
Set the Tire Pressures, and Initiate the TPMS
To prevent flat spots during vehicle shipping and storage, the tires are inflated to over
40 psi
. If the vehicle is going into
dealer storage, leave the tire pressures at
40 psi
until it is sold. When the vehicle is moved to the sales lot or is sold,
adjust the tire pressures as follows:
NOTE:
•
You must do these steps exactly as written to ensure the TPMS Fill Assist System works right.
•
If you are in a cold climate region, make sure the tires are at the same temperature as the outside air before
adjusting the pressures; otherwise, the Low Tire Pressure/TPMS indicator may come on in cold weather.
1. Turn the ignition to ON.
2. Set the pressure in each tire to the recommended value listed on the driver's doorjamb label, and check it with a
hand-held gauge.
3. Remove the TPMS label from each wheel. These labels are used by the factory to initialize the TPMS.
