After the unit is opened disconnect the connector from Test switch /Status LED board assembly, flex the snap at one side remove
Test switch/Status LED board from plastic cover carefully. Replace new Test switch/Status LED board and push the board towards
plastic cover carefully. Ensure that board is properly assembled then connect connector and close the unit.
TEST SWITCH/STATUS LED BOARD REPLACEMENT:
Page 6
MAINTENANCE and WIRING DIAGRAM
Connector
To remove IR board, release snaps
Federal Communications Commission (FCC) Requirements:
This device complies with FCC Title 47, Part 15, Subpart B. This
device does not cause harmful interference.
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
AFFINITY
®
AC Input Line Pin Details
Pin 1 White:
Neutral
Pin 3 Black:
HOT 120-347Vac
AC Input Line
(OEL Units)
Pin 1
Pin 3
WIRING DIAGRAM
Battery
Status LED/
Test Switch/
Infrared
activator Board
WT Lamp
WT Lamp
AC Input Line Pin Details
Pin 1 White:
Neutral
Pin 3 Black:
HOT 120-347Vac
Pin 4 Red or Yellow:
Switched-HOT 120-347Vac
AC Input Line
(PEL Units)
Heater Connector
(CW Optional Only)
Day Light Sensor
Pin 1
Pin 4
Pin 3
Programming
Connector
912-00020-001
Rev. D, 3/2021
© 2020, Acuity Brand Lighting,Inc.
All Rights Reserved.
Note: PEL units can not be
configured to OEL in the field
Note (PEL):
For switched line applications
only the PEL unit(s) shall be connected.
No other switched products shall be
connected on the switched leg.
