Nylon Washer
Hex Nut
1
Remove the nut and washer from
the lamphead and carefully remove
the lamphead from the housing.
2
LAMP REPLACEMENT
page 5
MAINTENANCE
With unit open, disconnect
the lamphead harness from
the charger board. Refer to
wiring diagram from page 6
for lamphead connectors on
charger board.
CHARGER BOARD REPLACEMENT
1
Reconnect all harness and position the
end of the charger board tray onto guide
rails and push down until you hear a
“snap”. Route wires along the side of the
guide rail to avoid wires from pinching.
Battery harness must be routed through
flap in dielectric cover.
2
Lift charger board tray and open
dielectric cover. Disconnect all
harnesses connected to the charger
board.
3
To remove the charger board from tray
release snaps (5x) and remove. To
install new charger board place over
snaps in correct orientation with dielectric
cover installed under the charger board
as shown. Press down firmly until snaps
engage.
Tray
Snaps
Charger board
To reinstall lamphead, route harness
through housing, washer and nut and then
tighten nut down a ¼ turn after the gasket
begins to compress. Connect lamphead
harness to charger board (see page 6 for
wiring diagram).
3
Dielectric
Cover
Battery harness
routing location
