MAINTENANCE and WIRING DIAGRAM
After the unit is opened disconnect the connector from Test
switch /Status LED board assembly, flex the snap at one
side remove Test switch/Status LED board from plastic
cover carefully. Replace new Test switch/Status LED board
and push the board towards plastic cover carefully. Ensure
that board is properly assembled then connect connector
and close the unit.
.
STATUS LED/TEST SWITCH
BOARD REPLACEMENT :
Connector
To remove IR board, release snaps
Federal Communications Commission (FCC) Requirements:
This device complies with FCC Title 47, Part 15, Subpart B. this
device does not cause harmful interference.
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
AFFINITY
®
WIRING DIAGRAM
WT Lamp
WT Lamp
FCT Lamp
DC Input wire details
White with Red stripe:
Positive (+)
White with Black stripe:
Negative (-)
“
Forward/Wide
"
button
Fig 1
Page 5
Status LED/
Test Switch/
Infrared
activator Board
912-00021-002
Rev. CA, 2/2020
© 2020, Acuity Brand Lighting,Inc.
All Rights Reserved.
