16
INSTALLATION GUIDE
TROUBLESHOOTING
1.
CAUTION. Turn off the gas supply prior to the next step.
2.
Using a clamp on the ammeter, clamp the ammeter around one of the wires providing power to the
Electronic Ignition System.
3.
Turn the fire feature on.
4. The amps you should see will range between 1.4 to 1.6 amps initially. Four seconds after being
turned on the amps will jump to approximately 2.0 amps.
If you do not see the amps listed above AND the wire gauge used was less than 12 gauge wire - change
the wiring. Otherwise contact Acucraft for further assistance: 763-263-3156.
SAMPLE
Summary of Contents for Outdoor Linear 8 Burner System
Page 8: ...8 INSTALLATION GUIDE S A M P L E...
Page 9: ...9 INSTALLATION GUIDE S A M P L E...
Page 10: ...10 INSTALLATION GUIDE S A M P L E...
Page 21: ...21 NOTES S A M P L E...
