Acucraft circular 4, Operator'S Manual

Page: 39 / 46

39
PRODUCT SPECIFICATIONS PRODUCT SPECIFICATIONS
FOR YOUR SAFETY, READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury, or loss of life.
A. This appliance has a pilot. It is equipped with an ignition
device which automatically lights the burner. Do not try
to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
x Do not try to light any appliance
x Do not touch any electric switch; do not use any phone
in your building.
x Immediately call your gas supplier from a neighbor’ s
phone. Follow the gas supplier ’ s instructions.
x If you cannot reach your gas supplier, call the fire
department.
C. Only use your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don’ t try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been under
water.
OPERATING INSTRUCTIONS
4. Push in gas control know slightly and turn clockwise
1. STOP! Read the safety information above on this label.
2. Turn off all electric power to the appliance.
3. This appliance is equipped with an ignition system which
automatically lights the burner. Do not try to light the
burner by hand.
to “OFF”
Note: Knob cannot be turned to “OFF”
position unless knob is pushed in slightly.
Do not force.
5. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the safety information above on
this label. If you don’t smell gas, go to the n ext step.
6. Turn gas control knob counterclockwise
to “ON”
7. Replace control access panel.
8. Turn on all electric power to the appliance.
9.
If the appliance will not operate, follow the
instructions “To Turn Off Gas To Appliance” and call
your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to the appliance if service is to
be performed.
2. Remove control access panel
3. Push in control knob slightly and turn clockwise
to “OFF” Do not force
4. Replace control access panel
DRAFT