Mounting options can be adapted to machine mounting surfaces
using spacers, standoffs, or leveling set screws.
Measuring length and mechanical configuration of your equipment
determine your options.
Backup spar mounting is an option but not required for lengths
up to 60.
Backup spar uses the same mounting procedure as is used with
mounting the scale case. Follow these steps for alignment and
hole location.
Less than 24
:
Use end mounting holes.
Over 60
:
A backup spar is required.
7
ACU-RITE
®
ENC150
Mounting Requirements
1/4-20 x 1 BHCS
& scale washer
End hole mounting
1/4-20 x 1/2 BHCS
and spar washer
Backup spar
mounting
24 to 60
:
Use end mounting holes with center supports.
.75 [19]
1/4-20 x 1 BHCS
Typical
8-32 x 1
SHCS
Linear
Encoder
washer
Center
support
End hole mounting
with center support
M4 x 8mm
SHSS
