33
Appendix A - Remote Controllers
10 Appendix A – Remote Controllers (Advanced Setup)
Your zControl starter kit may include a remote controller or one can be purchased separately from your service
provider.
The Intermatic CA-09 Wireless Remote Controller is an optional accessory that enables you to control your devices
from a remote controller as well as from the zControl Interface. If you would like to control your devices with this
remote controller, please follow these steps to configure your home network and zControl to use this remote.
NOTE:
Once the remote controller is configured to control your Z-Wave devices, you will no longer be able to add
devices using the Z-Wave button on the front of the zControl or using the
Add
button in the zControl Interface. The
remote controller will act as the primary controller in your home and additional devices will be added using the
remote controller.
10.1 Preparing the zControl to use the Remote Controller
Open your zControl Interface.
›
Turn on Administrator Mode and then click on the Settings icon in the bottom-right corner
›
Click on the Z-Wave icon
›
You must manually remove each Z-Wave device previously added to your zControl by using the
›
Remove
but-
ton, followed by the Program button on the Z-Wave device. Wait for confirmation that the device is removed.
Repeat this step for each device in your home before proceeding to the next step.
10.2 Setting Up the Intermatic CA-09 Remote Controller
Now you must add control for each Z-Wave device module on the remote control and assign a channel number for
each device. (Full instructions can be found in your remote controller manual)
Adding Z-Wave modules to the network:
Press the
›
INCLUDE
button on the remote and verify that the green LED is flashing.
Press the program button on the Z-Wave module you wish to learn and the green LED should turn SOLID
›
indicating that it successfully learned the device.
Associating Z-Wave modules to a channel on the remote controller:
Press the ON and
›
OFF
buttons together for 5 seconds for the desired channel on the remote you wish to set
up until both Red and Green LEDs are blinking.
Press and hold the
›
INCLUDE
button and while holding, press the
Program
button on the Z-Wave device until
the LED flashes and turns SOLID green.
The device has been successfully associated to the channel you selected.
›
You can confirm by pressing the
›
ON
/
OFF
button and verify that your device turns on and off.
Summary of Contents for zControl
Page 1: ...USER MANUAL zControl ...
Page 2: ......