Managing Z-Wave Devices
14
5 Managing Z-Wave Devices
5.1 Adding Z-Wave Devices
There are many different kinds of Z-Wave devices. These include lamp modules, thermostats, motion/occupancy
sensors, blinds/shades, fans, appliance modules, and so on. There is one simple installation procedure for all of
these devices:
Plug in the Z-Wave device within six feet of the zControl
1.
Push the blue
2.
Z-Wave
button on the front of the zControl. The
Activity
LED will begin blinking green slowly
Push the button on the Z-Wave device (it will be labeled
3.
On/Off
,
Service
,
Program
, or something similar)
When the
4.
Activity
LED turns solid green or starts blinking green rapidly, the Z-Wave device has been success-
fully added
If the
5.
Activity
LED blinks red slowly three times, the Z-Wave device has not been successfully added. Go back
to step 1 and repeat the procedure
Repeat steps 1 through 5 for each Z-Wave device
6.
Unplug your Z-Wave devices and plug them into their intended places in your home
7.
Open your zControl User Interface
8.
Turn on
9.
Administrator Mode
and then click on the
Settings
icon in the bottom-right corner
Click on the
10.
Z-Wave
icon
Click on the
11.
Rediscover
button
Click on
12.
Devices
. The list should now include the new Z-Wave devices
NOTE:
If you unplug a Z-Wave device (to move it to another location, for example) after completing this proce-
dure, you will need to
Rediscover
it. If this does not work, you may need to repeat the installation procedure
for that device starting from step 1.
5.2 Adding Z-Wave Devices (UI method)
Open your zControl User Interface
1.
Turn on
2.
Administrator Mode
and then click on the
Settings
icon in the bottom-right corner
Click on the
3.
Z-Wave
icon
Summary of Contents for zControl
Page 1: ...USER MANUAL zControl ...
Page 2: ......
