ENR-
100 Series System Administrator’s Manual
Configure Network Settings
There are two network interface cards in ENR.
Either of these cards can be supported by the built-in DHCP server feature, which enables
ENR to assign IP addresses to cameras via
LAN1
or
LAN2
port without another DHCP on
router.
By default,
LAN1
card uses a fixed IP address
192.168.0.10
, while
LAN2
is in
DHCP
client
mode. It is suggested that you connect
LAN1
to LAN and connect
LAN2
to WAN.
Current IP Configurations
Go to
Setup
page
Network
tab.
IP Settings
On
Network
tab, click
“
Network Connection
” then select the interface card that you wish to
set up. After setting up, please click
“
Save
” on the bottom right side to save the settings.
LAN1 Configuration LAN2 Configuration
