Note
:
In the case of a fault, you are advised to contact
the supplier of your P M
AX
N
EWTRON
XS. Do not use
unauthorized repairers, who might make your
device dangerous for you and your patients.
IX - MAINTENANCE
9. 1 FUSE REPLACEMENT
P M
AX
N
EWTRON
XS is protected by two fuses
located in the power receptacle (Fig. 2-1).
The replacement procedure is as follows:
- Switch the device off (position OI).
- Unplug the power cord from the electrical
supply.
- Unplug the power cord from the power
receptacle (Fig. 2-1).
- Insert the tip of a flat blade screwdriver into
the notch above the fuse drawer to release it
(Fig. 2-5)
- Remove the old fuses.
- Replace with new fuses of the same type and
rating.
- Push the fuse drawer back into its housing until
it clicks to indicate the correct position.
- Plug the power cord into the receptacle (Fig. 2-
1).
- Plug the power cord into the electrical supply.
Note
:
The device also has an internal fuse not
accessible to the user (referenced FUS1 on the
printed circuit).
Contact the SATELEC after-sales service (refer to
chapter 2 - Repairs).
All the information necessary for the repair of
faulty components is made available by SATELEC
to the technical personnel of the SATELEC-
approved dealer network who carry out the work.
9. 2 OPERATION FAULTS
Refer to the following table.
15
