EXP-06E Access Control System Installation Instruction
Satcom Systems (International) Co., Ltd.
7
proximity card reader will sound three sort " beep-beep-beep". For security reason,
the key Operation can only be tried 3 times. After than the Key Operation will be
terminated for this card only. Card operations then need to reset the termination.
6.5 Turn ON/OFF Control Relay by User Card with Pin Code
At this function mode, user must press "9" button in the keypad and hold it on and
present the card. If this card user's "AUTHORIZE LEVEL" is allowed to operate this
function, the proximity card reader's LED light will hold on 5 seconds to green color,
user should release key "9" button in the keypad and key in 4 digits the current used
pin code. If the card user is authorized and the pin code is correct, the proximity card
reader will sound a long "beep". Then the control relay will be turn ON or OFF.
Otherwise, the proximity card reader will sound three sort "beep-beep-beep" for
"INVALID AUTHORIZE LEVEL" OR "WRONG PIN CODE".
6.6 Change Pin Code by User Card with Current Pin Code
User can change the pin code that is related to the card issued to him. At this function
mode, user must press "0" button in the keypad and hold it on and present the card. If
the information of the card is stored at data memory of the controller. the proximity
card reader's LED light will hold on 5 seconds to green color, user should release key
"0" button in the keypad and key in 4 digits the current used pin code. If the key in pin
code is correct, the proximity card reader's LED should change to red color; user then
is to ready key in 4 digits new pin code. The proximity card reader's LED should
change to green color and user should key in same 4 digits new pin codes again for
verification. If the verification pin code is correct the proximity card reader will sound
a long "beep". Then the new pin code is started to active. Otherwise, the proximity
card reader will sound three sort "beep-beep-beep" for incorrect verification by "NOT
MATCH NEW PIN CODE". Then user is still using the old pin code.
6.7 Turn ON/OFF Control Relay by User Card with Duress Pin Code
If duress alarm function interfaced with alarm control panel, user can use this function
for under duress active.
At this function mode, user must press "9" button in the keypad and hold it on and
present the card. If this card user's "AUTHORIZE LEVEL" is allowed to operate this
function, the proximity card reader's LED light will hold on 5 seconds to green color,
user should release key "9" button in the keypad and key in 4 digits "Duress Pin Code.
If the card user is authorized and the duress pin code is correct, the proximity card
reader will sound a long "beep". Then the control relay will be turn ON or OFF and at
the same time access controller send out a duress alarm signal to alarm control panel.
