EtherStax™ ES2163/2164 User’s Manual Modbus TCP/UDP/IP Analog Input
___________________________________________________________________
_______________________________________________________________________________________
Acromag, Inc. Tel:248-295-0880 Fax:248-624-9234 Email:
http://www.acromag.com
9
0.84"
2.44"
2.29"
7.74"
2.29"
3.28"
5.51"
0.25"
35mm x15mm
DIN RAIL
SUBTRACT 0.59" FROM DIMENSIONS SHOWN IF USING
ESA-SMK BASE-PLATE (NO DIN RAIL MOUNT).
UP TO 3 UNITS MAY BE STACKED ON A DIN RAIL USING ESA-DIN-HMK AS SHOWN.
ETHERSTAX ESA-DIN-HMK STACKING
To attach or remove the ESA-DIN-HMK to/from the DIN Rail, use a
screwdriver tip inserted into the slot at the end of the DIN clip, in the area of
the notch of the base-plate as shown below. Pry back to compress the DIN
clip spring, then release it from the rail. You may have to temporarily unplug
the terminal blocks in the area of this notch to gain access to the DIN clip.
09
11
13
15
25
27
29
31
2
1
01
03
0
07
6
C
17
19
21
23
PORT 2
DFT
08
10
12
14
TS1
24
26
C
28
30
TS2
RST
COM
STATUS
00
02
04
16
18
C
20
22
PORT 1
ETHERNET 10/100M
LOCATE DIN LATCH IN AREA OF NOTCH IN BASE-PLATE
35mm x15mm
DIN RAIL
ETHERSTAX ESA-DIN-HMK
REMOVAL FROM DIN RAIL
Acromag
USE A SCREWDRIVER AS SHOWN TO PRY BACK
ON DIN RAIL LATCH AND RELEASE UNIT FROM RAIL.
IT MAY BE NECESSARY TO TEMPORARILY UNPLUG
TERMINAL BLOCKS TO GAIN ACCESS TO DIN LATCH.
MOUNTING AND
DIMENSIONS
IMPORTANT:
Be sure to
remove power before
attempting to disengage unit
from the DIN rail.
Be sure to grip unit firmly
before disengaging unit from
rail and avoid dropping it.
Note that you can stack up to
3 units on the ESA-DIN-HMK
or ESA-SMK as shown at left.
Subtract 0.59 inches from
dimensions shown if using
ESA-SMK (i.e. no DIN rail
mount).