EtherStax™ ES2163/2164 User’s Manual Modbus TCP/UDP/IP Analog Input
__________________________________________________________________
_______________________________________________________________________________________
Acromag, Inc. Tel:248-295-0880 Fax:248-624-9234 Email:
http://www.acromag.com
8
1
2
3
Bolt to wall or flat surface using
1/4 bolts (not provided) at each
corner. Use a flat washer at the
grommet interface as shown.
You will have to temporarily
unplug terminal blocks to
insert bolts through grommet.
Insert rubber grommet
provided into holes at
each corner of baseplate.
FLAT WASHER REQUIRED, 4 PLACES (NOT INCLUDED)
ETHERSTAX SURFACE MOUNTING WITH ESA-SMK
Attach baseplate to
enclosure using four
1/4-20 flat-head bolts
provided. Insert bolts
through counter-sink
side of baseplate.
DIN Rail Horizontal Mount Kit ESA-DIN-HMK (one to three units):
This
kit has the same base-plate as ESA-SMK above, but adds a heavy-duty DIN
adapter (Phoenix UTA-159), and screws for mounting to 35x15mm T-type
DIN rails. Up to three units may be stacked on this plate and mounted to a
DIN rail.
0.10"
35mm x15mm
DIN RAIL
NOTCH FOR ACCESS TO
DIN CLIP RELEASE TAB
(Insert screwdriver here to
pry back spring clamp and
release unit from rail)
ETHERSTAX MOUNTING WITH ESA-DIN-HMK
ESA-DIN-HMK Kit Contents:
1
Pre-Drilled Aluminum Base-Plate, 8 x 8 x 0.125.
4
¼-20 x 0.375 Flat-Head, 100° Counter-Sink
4
Rubber Grommet, 0.625 O.D. x 0.266 I.D.
1
Heavy-Duty DIN Adaptor (Phoenix UTA-159)
7
4-40 x 0.25 screw with lock-washer
MOUNTING AND
DIMENSIONS
This is the recommended
mounting orientation for
reducing internal heat
generation (see Ambient
Operating Temperature at the
back of this manual).