INSTALLATION INSTRUCTIONS
Check pump operation by filling the sump with water and
observing the pump's operation through one complete cycle.
CAUTION:
Failure to make this operational check may lead to
improper operation, premature failure, and flooding.
6.
WARNING:
Inspect the work area before each use. Keep work area clean, dry, free of clutter, and well lit. Cluttered,
wet, or dark work areas can result in injury. Using the tool in confined work areas may put you
dangerously close to other cutting tools and rotating parts.
Check for damaged parts before each use. Carefully check that the pump will operate properly and
perform its intended function. Replace damaged or worn parts immediately. Never operate the pump
with a damaged part.
Do not use the pump where there is a risk of causing a fire or an explosion; e.g., in the presence of
flammable liquids, gases, or dust. The tool can create sparks, which may ignite the dust or fumes.
Keep children and bystanders away from the work area while operating the pump. Do not allow children
to handle the pump.
Be aware of all power lines, electrical circuits, water pipes, and other mechanical hazards in your work
area. Some of these hazards may be below the work surface hidden from your view and may cause
personal harm or property damage if unintentionally contacted.
TROUBLESHOOTING
WARNING:
Do not disassemble the motor housing. This motor has NO repairable internal parts, and
disassembling may cause an oil leak or dangerous electrical wiring issues.
Problem
Possible Cause
Corrective Action
Pump does not
start or run
1.Replace fuse
2.Reset breaker
3.Secure plug
4.Clean plug prongs
5.Disconnect the pump from power
for 30 minutes, then reconnect
6.Contact customer service for
replacement
1.Blown fuse
2.Tripped breaker
3.Plug disconnected
4.Corroded plug
5.Thermal overload
6.Motor failed
Pump operates
but pumps little
or no water
1.Clean screen
2.Reassemble impeller
3.Contact customer service for
replacement
4.Secure pipe or hose
1.Pump screen or screen cover blocked
2.Impeller loose on shaft
3.Impeller broken
4.Pipe or hose loose.
6
