Tighten the M10 bolt connecting the
RiderPro mounting bracket to the Sentry
Post to a torque range of 40 to 80 inch-
pounds (4.5 to 9Nm).
Ref: IM 031 Rev 00
Date: 15/07/2021
Page 8/1
7
Property of
Margaritelli Ferroviaria S.p.A.
06135 Ponte San Giovanni - Italy
9
Installation to
the
ACP Sentry
T
hrie
Beam
Guardrail System.
9.1
New installation.
When supplied as part of a new guardrail barrier
installation, prior to commencing the installation of the
RiderPro
system, it is recommended that the
installation of the barrier is completed in accordance
with its “Product and Installation Manual”
.
9.2
Retrofitting installation.
When supplied for the retrofitting of an existing
guardrail barrier, prior to install the
RiderPro
system, it
is recommended to identify if the Sentry Post has a
RiderPro
12mm mounting hole located
6
0
0
mm from
the top of the Sentry Post. If the
RiderPro
mounting
hole is not present in these post be prepared to drill a
12mm hole
6
0
0
mm from the top of the Sentry Post.
9.3
Sequence of installation.
The major steps in the installation of
RiderPro
are as
follows:
1. Installing the mounting brackets;
2. Attaching and splicing the
RiderPro
beams
3. Installing the end terminals; and
4. Adjusting the ground clearance of the beams.
9.4
Attaching the mounting Brackets
Potential Hazards:
Injury from movements and
posture, hand injury from pinch points, strain to wrists
from tightening bolts and excessive noise from use of
impact driver.
Recommended Control Measures:
Observe correct
posture, wear gloves, use an impact wrench to
tighten bolts and wear appropriate hearing
protection.
The
RiderPro
mounting bracket is attached via
the 12mm mounting hole which is located
6
0
0
mm
from the top of the Sentry Posts and affixed using
the M10x25mm bolt.
Install the RiderPro mounting bracket now.
Figure
2
.
ACP Sentry Barrier: Attachment
of Mounting Bracket.
Figure
3
.
ACP Sentry Barrier: Mounting
Bracket attached (rear view).
