8
Take the selected 20 - 30 mm length M5 screw
with spring ring and washer attached.
Put it up through the suitable center hole on
the turntable mounting board and through
the center hole in the stainless steel lower
mounting plate (
3
).
Place the whole
AQUILAR
assembly directly
on top of the M5 screw and secure it in place
by screwing the M5 screw upwards through the
hole in armboard, through the lower mounting
plate into the center pillar of the
AQUILAR
.
Make sure to position the lower mounting plate
with the indents as pictured (
4
).
That way you can easily align the 3 levelling
spikes in the upper mounting plate in the
correct position towards the matching indents in
the lower mounting plate.
PLEASE NOTE
The 3 spikes MUST sit in the matching
indentions in the lower mounting plate.
Now tighten the mounting screw
JUST A BIT
-
not anywhere near maximum strength.
Do not use maximum force, just make sure it is
loosely tightened so that the mounting plate can
still be rotated in the horizontal plane.
The mounting screw will be fixed
during levelling the pivot plane.
The
AQUILAR
is now sitting in place.
If you use the
AQUILAR’s alignment
template -
detailed description on page 24
-
to determine the mounting distance, please insert
the 100 mm stainless steel pin careful into the
dedicated hole next to the thread for the position-
ing screw. Sharp tip downwards - open M3 thread
pointing upwards (
1
).
The pin has a sharp tip - be careful!
-
this can be used to mark the desiered spot on the
armboard. A controlled gentle hit with a small
hammer on the end of the pin will do (
2
).
1
2
3
4
