10
Now slide the alignment template into place
with the 8 mm hole thread at the end of its
outward positioning beam over the pivot
locating plate on the
AQUILAR
.
Now take the white knob fingerscrew and put it
into the 8 mm hole with the tip downwards.
The tip must meet the indention in the center of
the 12 mm pivot plate.
The
AQUILAR
should be positioned, so that
the underside of the armwand is approximately
2.5 cm / 1” above the turntable’s platter surface.
First you have to unlock the knob screw at
the inward side of the VTA tower by turning it
ONLY
1/4 revolutions anti-clockwise (
A
).
If you need to adjust for the above desired
height by lifting the
AQUILAR
in height above
the arm board, adjust the height using the top
VTA knob (
B
).
A
B
Important:
Always loose locking screw A first (1/4 turn
only) before doing any height adjustment at
top knob B !