13
6-3 Removal of operation part (wireless)
①
Raise the levers (2 places) and unlock the latches.
②
The operation part (wireless) can be removed by pulling it toward you.
③
When installing the operation part (wireless), connect the connector of the operation part to
the connector of the main body and lower the levers (2 places) and lock the latches.
④
Battery box is on the back side of the operation part (wireless). When the battery level is
low, remove the batteries from the battery box and charge them using the battery charger
that is included with the system.
⑤
Turning ON the power shall be made with the operation part (wireless) installed to the main
body. If the power is turned OFF while the operation part (wireless) is removed, “!! No
Response !!” will be displayed and the system becomes inoperable. Install the operation
part (wireless) to the main body and turn ON the power again.
⑥
10 minutes after the removal of the operation part (wireless), the display will go to sleep
mode (display will disappear). To return to normal operation, press any switch.
⑦
When using the operation part (wireless) while it is removed, use it within the distance of 10
m from the main body of the Proximity Exhaust Noise Measurement System. Use the case
opened with the lid at 90 degrees position and avoid using the system at a place where
interference is expected, such as near to devices that emits radio waves such as a radio.
6-4 Setting of printer paper
①
Press paper cover open button and open the paper cover.
②
Set the paper as shown in the following figure.
③
Make sure that the tip of the paper is outside of the cover and press the both sides of the top
of the cover to close the cover.
Latch
Latch
Lever
Paper cover open button
①
②
③
③
