45
DAS-208SA Disk Array User Guide
This will allow you to verify the integrity of the disk array immediately. The
“Quick Setup” assumes that there is only one partition on the disk array. To
start up, do the following steps:
Step 1
Press
ENTER
button to select to the “Enter Password” screen as
shown below in Figure 4-1. Use the
Up
and
Down
arrow button to
select your desired number for your Password (The default value is
00000000). Keep pushing ENTER button for the password. You will
receive a “Main Menu” option screen once you enter a correct
password. (See Figure 4-2)
Figure 4-1
Enter Passwd:
0XXXXXXX
Figure 4-2
Main Menu
0 Quick Setup
Step 2
Press
ENTER
to confirm your selection. This will bring you to set
the RAID level of the disk array. Use
UP
and
DOWN
arrow button
to select the RAID level. Press SEL to confirm your selection
again. Figure 4-3 shows the default value of the RAID set (RAID 5)
