4. How To Control The Unit
You can operate the unit in three ways:
1. Master/slave built-in preprogram function
2. Easy controller
3. Universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will
be effect at once. Every time you turn the unit on, it will show
on the display and move
all the motors to their ‘home’ position and you may hear some noises for about 20 seconds. After
that the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is good when you want an
instant show. You have to set the first unit in master mode and select
(random show) or
(show 1) or… or
(show 12) mode. Its DMX input jack will have nothing plugged into it,
and Its master LED will be constantly on and sound LED will flash to the music. The other units will
have to set in slave mode
and select
(normal) or
(2-light show) mode, Their
DMX cables plugged into the DMX input jacks (daisy chain) and the slave led lights will constantly
on.
2-light show
In
(slave mode),
means the unit works normally and
means 15-light show.
In order to create a great light show, you can set
on the fifteenth unit to get contrast
movement to each other, even if you have two units only.
4.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the
1/4” microphone jack of the first unit, you will find that the remote control on the
11A
