B. Not responding to DMX controller
1.
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
2.
If the DMX LED is on and no response to the channel, check the address settings and DMX
polarity.
3.
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
4.
Try to use another DMX controller.
5.
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
C. Some fixtures don’t respond to the easy controller
1.
You may have a break in the DMX cabling.
2.
Check the LED for the response of the master/ slave mode signal.
D. No response to the sound
1.
Make sure the fixture does not receive DMX signal.
2.
Check microphone to see if it is good by tapping the microphone.
E. One of the channels is not working well
1.
The stepper motor might be damaged or the cable connected to the PCB is broken.
2.
The motor’s drive IC on the PCB might be out of condition.
8. Fixture Cleaning
The cleaning must be carried out periodically to optimize light output. Cleaning frequency
depends on the environment in which the fixture operates: moist, smoky or particularly dirty
surrounding can cause greater accumulation of dirt on the fixture.
Clean with soft cloth using normal glass cleaning fluid.
Always dry the parts carefully.
Clean the external optics at least every 30 days.
16B
Summary of Contents for Color Par 36
Page 1: ...User Manual Please read the instruc on carefully before use CP 36S ...
Page 7: ...6B ...
Page 18: ...17B ...
