Acksys WLg-IDA/NP[H4], Quick Installation Manual

Page: 18 / 20

-8-
LEDs definition
13 status LED indicate:
LED Color Description
Power 1 Green
This led is ON when a power supply is connected
to pin PWR1 and GND1 of the power connector or
in case use of PoE if this function is available.
Power 2 Green
This led is ON when a power supply is connected
to pin PWR2 and GND2 of the power connector.
DIAG Red
This led lights up during a few seconds after
power up. When light up it indicates a product
dysfunction.
C-KEY
Bicolor
Orange/
Green
Off: no C-Key is detected.
Orange: the C-Key data is invalid or corrupted.
Green: the C-Key data is valid.
Blinking: during reads and writes to the C-Key.
WLAN
Blue Flashing according to WLAN Tx/Rx activity.
Bargraph Green
In Bridge mode, the four bars show the receive
level of the Wi-Fi interface. In AP mode, the four
bars blink until a client is connected.
Link
Tx/Rx
(ports 1&2)
Green
Lit when the link is established, blinks according
to TX/RX activity.
100 Base T
(ports 1&2)
Yellow
Indicates the connection speed: light off = 10
Mbps, yellow = 100 Mbps.
RESET
If it is not possible to shutdown the
power supply, a micro-switch
accessible by a hole located just in
front of the supply connector allows
resetting the product. You can use, for
example, a paper clip to press the
button. The press must be brief: if it
takes more than two seconds, the
product will reset to factory settings.