8
RAIL INSTALLATION
NOTE:
For upright installation, see page 10.
1: PREPARING CLAMP ASSEMBLY AND RAILS
IMPORTANT: Stake pockets must be open to install this product.
ASSEMBLE THREADED CLAMP
A. Loop cord around extended threads on
clamp plate, add alignment plates equally
then tie knot at top of cord.
NOTE:
Each cord should have a threaded
clamp plate and one or more alignment plates.
Tie loose ends
in a knot
Alignment
plates
(quantity
varies)
Clamp plate
Extended threads
RAILS WITH MOUNTING CHANNELS
NOTE:
If your rails do not have mounting
channels, proceed to Step 2.
A. Place rail on fl at surface and insert (4)
channel nuts with extended threads facing
away from slotted hole.
TIP:
If installing optional rail accessories,
insert additional channel nuts to support
the accessories. For more information see
accessory instructions.
Mounting channel
Channel nut
Slotted hole
B. Insert rail end caps into both sides of rail.
C. Tighten rail end cap retaining screws with
Phillips screwdriver.
D. Repeat for remaining rail.
Rail end cap
Retaining
screw
