Acer Supra 818PD, Operation Manual

Page: 87 / 238

818~2040PD
33
CHAP. 5 APPENDIX
5-1 COPY DISPLAY TO USB
5-1-1 USB
The USB is used for saving the control data, and copying control data.
The support file format is FAT32. Suggested capacity is under 1GB. When
applying USB for saving data, if you need to remove USB, be sure to shut off
write-in motion to ensure the data completeness. There are two types of
write-in motion:
1. Keep pressing the control system for 3 seconds for entering into the control system
display (In case there is no password locking the system key). Then control will turn off
USB.
2. Change the screen to power on display, and press the right lower corner on the display,
then the control will turn off USB (NOTE 1).
The two methods mentioned as above are used for removing USB. To remove USB,
be sure to follow above mentioned two methods that will ensure completeness of contents
in USB.
5-1-2
：
DESCRPTION OF DISPLAY COPY
1. Enter into user man agent display at first
→
operator
→
system parameter
setting
→
keep relay set (user) display, then copy display to USB (0:
cancel. 1: use). This function is set at “1”. The parameter is controlled by
password.
2.
Insert the USB into the “USB HOST” position located at the back side of
the control. Change the screen to the display to be copied, and then press
the left top corner of the screen. When the system display a message of
during copying, do not remove the USB. After copy, if you need to remove
the USB, do it according to the correct procedures to ensure completeness
of contents in the USB.
Press this position for copying your
desired display to the USB.
USB insert
position
NOTE 1:
Using this method according to the procedures as following. System user
management display
→
Operator
→
System parameter setting
→
Keep
relay set (user), then “copy display to USB (0: cancel. 1: use).” This
function is set at “1”. The parameter is controlled by password.
Press this position only on the power
on display for removing the USB.