
Chapter 1
19
Southbridge
System Clock
Crystal and Oscillator
System Memory
Item
Specification
Chipset
AMD SB 700
Features
•
A-Link Express II Interface to AMD North bridge, High data transfer
Bandwidth up to 2.5GT/s/Lane
•
USB controllers, 5 OHCI and 2 EHCI host controllers to support 12 USB
2.0 ports and 2 dedicated USB 1.1 ports
•
SATA controllers , Support six SATA II ports with transfer rate up to 3Gb/s,
Support both SATA 1.5 and SATA 3.0 compliance devives, Supports E-
SATA raid support and AHCI support
•
Interrupt controller, Support IOAPIC/X APIC mode for 24 channel of
interrupt
•
High definition Audio support up to 4 codec's and up to 192Khz sample
rate and 32 bit audio
Power
1.2V, 1.8V, 3.3V, 5V
Package FCBGA
528-pin
Item
Specification
Chipset
SLG8SP628VTR
Clock Synthesizer
•
200MHz for CPU
•
100MHz clock buffer for RS780MN, SB 700, PCIE device
•
96MHz for RS780MN
•
48MHz for USB clock inside SB700, Card reader
•
33MHz PCI clock for PC device, LPC
Features
•
Support spread spectrum function, for reducing EMI
•
Support SM bus interface
Power
3.3V, 1.2V
Package
64 pin QFN
Item
Specification
Features
•
14.31818 MHz crystal for clock chip
•
32.768 KHz crystal for SB700 and WPCE775C
•
25Mhz crystal for LAN AR8182
•
25Mhz for SATA control inside SB700
•
12Mhz for finger printer control
Item
Specification
Features
•
DDR II 667/800MHz SDRAM memory interface design
•
2 DDR SODIMM slot
•
Maximum memory up to 4GB-SODIMM
Summary of Contents for LX.AUQ0X.080 - Aspire 6530-5195 - Athlon X2 1.9 GHz
