55
Upgrading the processor
Processor configuration guidelines
Altos R520 M2 supports two LGA 1366 processor sockets supporting
dual-core or quad-core Intel Xeon processors. You have the option to
upgrade the default processor or install a second one for a dual-
processor configuration.
Observe the following guidelines when replacing or installing a
processor.
•
The processor 1 socket must always be populated. If no processor is
installed in this socket, the system will fail to boot.
•
Before removing a processor, make sure to back up all important
system files.
•
When installing a second processor, make sure it has same
stepping and frequency specifications as the default processor.
•
Handle the processor and the heat sink carefully. Damage to either
may prevent the system from functioning properly.
To upgrade the default processor:
1
Perform the pre-installation instructions described on page 35.
Warning! The heat sink becomes very hot when the system
is on. NEVER touch the assembly with any metal or with
your hands.
2
Remove the air duct. Perform the instructions described in “To
remove the air duct” section on page 41.
3
Remove the heat sink.
(1) Loosen the four captive screws on the heat sink.
Summary of Contents for Altos R520 M2
