System Housing
2-23
2.4
Installing a Hot-swappable SCSI Drive
Remove all jumper connectors on the SCSI
drive before installing it into the system. Also,
for Single-Ended (SE) SCSI drives, remove the
terminator jumper before connecting the SCSI
drive to the system. For the location of the
jumper connectors and the terminator jumper,
please refer to your hard drive’s instructions or
manual.
The system supports up to eight hot-swappable drive trays.
Follow these steps to install a hot-swap SCSI drive:
1. Open the front panel door.
2. Use your finger to release the drive tray as shown below and then
pull it out.