CAUTION
■
■
■
Always check the FAILSAFE function after each binding.
Pre-setting will be executed unless you reset the FAILSAFE.
FAILSAFE function ALWAYS memorizes the latest settings if
you do not manually reset the FAILSAFE function after a new
system binding.
6. Flying a RC Flight-Simulator
Use a suitable interface device to connect the mini USB port (located
on the back of the transmitter) to a personal computer and directly
on your simulator.
8
NOTE
Pre-settings for the FAILSAFE Function are:
■
Throttle at idle position (Throttle stick is at lowest)
■
The other channels are at neutral position.
5. FAILSAFE Function Setting
ACE RC TS4 system features a built-in Pre-setting Failsafe function
to automatically set a servo command if the receiver loses the signal
from the transmitter due to interference. For safety, we strongly
recommend to check the FAILSAFE function before flying.
Resetting FAILSAFE
FAILSAFE settings can be reset by pressing the Binding Switch on
your receiver (power on). First, ensure your radio system is bound
properly and proceed as per the following:
a) Power on your TS4 transmitter & Receiver. Move and hold control
sticks to preferred position should a failsafe situation occur
(select any channels from CH1~CH4). Factory pre-settings are
recommended, please refer to “Note”.
b) Press & hold the binding switch on the receiver for 4 seconds.
c) When the LED on the receiver starts blinking, release the binding
switch then the LED turns to red for 2~4 seconds then turn back
to green, indicating the function is successfully set.
Press & hold Binding switch...
d) Test by turning off your transmitter and observing the servo failsafe
position activates, next turn off your receiver.
Test by turning off your transmitter and watching the
servo failsafe position activate.
Release Binding switch when
flashing in GREEN
Turn to RED
for 2~4 seconds
Turn back to GREEN
indicating the FS is success
LED
LED
Binding Switch
Binding Switch
AQ2257
TRS601DD
AQ2280
TRS401SS
Receiver
4CH
Receiver
6CH
e) Switch on the transmitter & receiver again, and ensure that all servos
follow the movements of the sticks before you fly.
f) If fails or need to reset the Failsafe then repeat step a) ~ e).
