CAUTION
4
Servos
Mount the servos as recommended in your model's instruction manual.
Receiver installation
Note the location of the receiver in your model's instruction manual or
building plans.
NOTE
We assume that all areas where large currents are flowing are
generating noise, and noise is a type of radio wave. It is important to
reduce the possibility of interference by locating a proper position for
receiver and antenna.
Throttle servo used on
gas powered model
R6(AA),LR6
Ni-Cd or Ni-MH Battery
Switch
Harness
Receiver
Ensure the contacts in the battery holder stay clean by using a pencil
eraser to gently remove any corrosion or dirt that may accumulate. It is
recommended to do this each time you install fresh cells into your
battery holder.
Radio installation
Before installing your radio into your model, connect the receiver, servos,
and switch harness/battery pack as shown. In addition to checking for
proper operation, this "bench test" helps you become familiar with the
operation of your radio. Begin by turning on the transmitter, and then turn
on the receiver switch. Make sure that all servos and trims levers are
operating, and take a few moments to "play" with your system. After
completion of your bench testing, turn off the receiver, followed by the
transmitter.
Receiver battery replacement/installation
Insert 4 fresh AA cells into the receiver battery holder. Ensure
the batteries
are loaded in the correct polarity order. Maintain the battery contacts in
the same way as described in previous section.
Insert the switch harness plug into the receiver socket marked "BATT"
