![ACE RC SkyMaster TS4 Instruction Manual Download Page 4](http://html1.mh-extra.com/html/ace-rc/skymaster-ts4/skymaster-ts4_instruction-manual_3901961004.webp)
Battery cover
Transmitter batteries replacement/installation:
1)
2)
3)
4)
Slide the battery cover in the indicated direction to remove the cover.
Install 8pcs alkaline or rechargeable “AA” size cells into the battery
holder connected to the transmitter.
Slide on the battery cover and ensure it is locked properly.
Turn the power on to check. If the Power Indicator LED fails to light,
check the batteries for insufficient contact or incorrect battery polarity.
Installation
NOTE
a)
b)
c)
d)
Use only same brand, fresh, alkaline cells.
Ensure all contacts in the battery holder are clean by using a pencil eraser
to gently remove any corrosion or dirt that may accumulate. It is
recommended to do this each time you install fresh cells into your
transmitter.
If using rechargeable 9.6V battery pack, remove the battery holder by
pulling out the connector from the transmitter. Then plug-in the
battery-pack connector to the transmitter.
When rechargeable batteries are installed in the transmitter, these can be
charged through the external charging jack located on the transmitter.
CAUTION
a)
b)
c)
d)
Do not attempt to charge alkaline batteries, they may explode!!
When charging rechargeable batteries, turn off the power switch before
charging. The charger plug must be of the correct type (“+” inside and
“-“outside, type TAMIYA N-3U or equivalent). Incorrect charger plug
type may provoke an explosion, causing personal injuries and
damages.
Always ensure batteries are loaded in the correct polarity. If the
batteries are loaded incorrectly, the transmitter may be damaged.
When the transmitter is not used for any short / long period of time,
always remove the batteries from the transmitter.
Battery cell (x8)
While pressing
this part
Cord to transmitter
external charging jack
HELPFUL HINT
You may also use the NiCd or
NiHM rechargeable cells. They
can be charged through the
charge jack located on the side
of the transmitter. The ACE
2970/2971/2972 Radio battery
conversion kits are
recommended.
CAUTION
When the transmitter is not used for any short or long period, always
remove the batteries.
3