Section II: Startup & Operation
4. Thoroughly clean the body and tube using the draw-
off cleaner brush provided with the Legion Care Kit.
5. When through, rinse with clean water and re-assemble,
taking care not to over-tighten the draw-off. It is designed
to be hand-tightened only.
We’ve already started the unit up during installation. Now
we’ll examine all control functions, step by step, for a full
understanding.
IMPORTANT: After installation or service and prior to
operating the unit, make sure the following are done,
otherwise the unit will not operate.
Make sure the ignition system control knob is in the
ON
position.
Make sure the main electrical power and the gas
supply to the unit have both been turned on.
Fig. 2.1 Control Panel Features
Rocker Switch (On - Off).
Energizes the unit for operation.
Primary Thermostat Dial (Temperature).
Allows the user
to set the cooking temperature of the unit.
Unit Power On Indicator Light (Green).
Illuminates upon
depressing the rocker switch to the ON position. This
indicates the unit has been energized.
Heater Power On Indicator Light (Red).
Illuminates upon
turning the thermostat dial to show that the infrared
burners are operating. Note: If the temperature of the
unit is already above the set temperature, the red heater
power on light will not come on.
Low Water Indicator Light (Amber).
It alerts the user that
the water level in the steam jacket has fallen below the
recommended operating level and that the low water
relay has been activated, turning off the burner as a
safety precaution until the low water condition has been
remedied (Refer to Section III, Service & Maintenance,
Item 4, Filling Steam Jacket). Once the water level has
been increased to normal working levels the low water
relay will reset and permit normal operation.
Control Functions
Summary of Control Functions:
9
