Receiving and Unpacking
Receiving
Upon receiving the product, check to make sure all
items are accounted for by referencing the bill of lading
or packing list to ensure all items were received. Notify
the carrier if any damage is noticed. The carrier will
make notification on the delivery receipt acknowledging
any damage to the product. All damage should be
noted on all of the copies of the bill of lading which is
countersigned by the delivering carrier. If damaged upon
arrival, file a claim with the carrier. Any physical damage
to the unit after acceptance is not the responsibility of
the manufacturer.
Unpacking
Verify that all required parts and the correct quantity of
each item have been received. If any items are missing,
report shortages to your local representative to arrange
for obtaining missing parts.
Storage
If a temperature interlock must be stored prior to
installation, it must be protected from dirt and moisture.
Indoor storage is highly recommended.
Handling
Make sure the equipment does not suffer any heavy
vibration or knocks.
NOTE
Improper storage which results in damage to the unit
will void the warranty.
Control Box Mounting
Installation
Locate an area with enough space to mount the control
box and fasten to the wall. Avoid installing the control
box in environments with high magnetic and/or radio
frequency interference.
Hood Plan View
19.525 inches
(495.9 mm)
3 inch air space
(76.2 mm)
2 inch typical
(50.8 mm)
Exhaust Area
Supply Area
(optional)
Sensor Install
(cut out area)
2. Find a suitable
location for the sensor
in the flat space that
will not interfere with
the fire suppression nozzles
and that is not within
12 inches
(304.8 mm)
of
any light fixtures. Cut a 1
1
⁄
8
to 1¼ inch
(28.6 to 31.8 mm)
diameter hole in the flat spot of the capture tank.
3. Place the J-box plate inside the octagon extension
ring and place over the hole.
4. Disassemble the compression seal and place
through hole and J-box plate as shown. Tighten the
nut inside the octagon extension ring.
1. Locate the flat area(s) at the top interior of the hood
in front of the filters, towards the front of the hood.
Hood Surface
(28.6 to 31.8 mm)
NOTE
Control box may be factory mounted. If so, continue
to the next section.
NOTE
Thermostat sensor(s) may be factory installed. If so,
continue to the next section.
Thermostat(s) - Hood Mounting
Gasket
Compression Seal
PN 452614
Nut
Lock Washer
Octagon Extension
PN 830125
Junction Box Plate
PN 732396
Exploded View (Components)
Temperature Interlock
3
