Instruction Manual SP 2-10-2 F4/F5
3
Model Features:
This limited production model has
been handcrafted for Accucraft Trains
by BMMC, which is one of the most
respected makers of large scale brass
models. This museum quality model
features:
•
Detailed boiler with fi ttings,
domes, pipes and handrails
•
Operating steel drive rods,
valve gear and cross heads
•
Prototypical livery and letter
ing
The following part is packaged sepa-
rately:
-
2mm hex head screwdriver
tools you will need for mainte
nance
- 1.5mm
Allen
Wrench
-
2mm hex screwdriver
-
Flat head screwdriver
-
Philips head screwdriver
Technical Specifi cations:
Scale/Gauge: 1:32, 45mm Gauge
Total Weight:
18 lbs
Length:
23 in.
Width:
4.5
in.
Height:
6.5 in.
Tender Information:
Length:
15 in.
Width:
4.25
in.
Height:
6 in.
Recommend Radius: 3M, 10ft.*
Boiler water capacity:
to top of water glass:
450ml
Tender water capacity: 600ml
Alcohol tank capacity: 500ml
*Be sure to leave at least 3” clear-
ance (measured from the inner rail) to
allow for overhang.
Caution!
This model is an accurate replica of the original locomotive. It has sharp
and moving parts. The locomotive drive rods are stainless steel with sharp
edges.
OPERATORS MUST NOT COME IN CONTACT WITH A MODEL THAT IS
BEING POWERED AT ANY TIME. UNDER NO CIRCUMSTANCES SHALL
ACCUCRAFT TRAINS BE RESPONSIBLE FOR ANY INCIDENTAL OR CON-
SEQUENTIAL DAMAGES ARISING IN REGARD TO ANY ACCUCRAFT
PRODUCT.
Instruction Manual SP 2-10-2 F4/F5
8
Please read following directions before unpacking your locomotive.
1. Remove foam around the locomotive. Slide the inner box cover to the side,
and open the inside cardboard box with a cutting knife.
2. Place taped locomotive on a fl at surface. Carefully cut the tape along the
wood board side surface. Be sure to cut both sides of the wood board. Slowly
lift the tape from the locomotive. Be very careful with small parts. Tape cannot
be re-used to re-pack the model. Use new packing tape if necessary.
