200
175
150
Figure 12:
200 psi
Tank Pressure Mode
E-LEVEL TANK PRESSURE MODE
Your e-Level system was shipped with the Tank Pressure Mode set at 150 PSI. ENDO-CVT requires you to change the e-Level Tank
Pressure Mode to 200 PSI using the following procedure.
To Change The Tank Pressure Mode:
With the Ignition ON, press the Program “ ” Button.
Next press the #3 DOWN “
” Button to set Tank Pressure Mode to 150 PSI, the #4 DOWN
“ ” Button once to set the Tank Pressure Mode to 175 PSI and the #4 DOWN “ ” Button
again to set the Tank Pressure Mode to 200 PSI.
When the #3 DOWN “ ” Arrow is White:
Tank Pressure Mode is at 150 PSI.
When the #3 DOWN “ ” Arrow and the #4 DOWN “ ” Arrow are alternating ON & OFF:
Tank Pressure Mode is at 175 PSI.
When the #4 DOWN “ ” Arrow is Red:
Tank Pressure Mode is at 200 PSI.
!
!
NOTE:
The new Tank Pressure setting will
NOT
take affect until the
system is
RE-CALLIBRATED.
NOTE:
Program Mode will exit after 5 seconds or can be exited by
pressing the Program Button again and your changes will be saved.
Page 15
ENDO-CVT Instructions V1.
2
AccuAir Suspension 2018