VEHICLE STANDARD MOUNTING
Your ENDO Tank system has been designed to use AccuAir’s unique Quick Release (QR) mounting system. The QR mounts
are installed on the tank at the factory and will need to be removed prior to installation.
The mounting template, included in the shipping carton of your ENDO system, has complete details on mounting your tank to
your vehicle. Accurate location of the QR mounts is critical for a successful installation.
Read all steps
before starting your
installation.
The QR mounting system has been designed to attach the ENDO Tank securely to a flat surface. Minor variations can be
handled with shims of appropriate thickness. If your intended mounting location is significantly uneven, AccuAir strongly
recommends mounting the QR bases to a suitable plate that is then installed on the vehicle.
AccuAir recommends mounting the QR mounting bases with the included 5/16”-18 screws or 1/4”-20 self-tapping screws at
120 in-lbs
(10 ft-lbs, 13.6 N-m) torque. Use care when tightening these fasteners as over-torquing can cause the QR bases
to distort.
Pro-Tip:
On first installation of the tank, tighten the bolts between the QR mounting bases and the vehicle until they are just snug.
Install the tank into its final position and let the mounts adapt, then remove the tank again to torque the bolts.
STANDARD MOUNTING:
!
NOTE:
The QR mounting “pins” have been pre-installed in the tank body with a thread locker.
If removed, then upon re-installation apply a thread locker (Loctite 262 or equivalent) to the
threads and torque to
40 in-lbs
(3.3 ft-lbs, 4.5 N-m). Significantly over-torquing these
fasteners may cause damage to the tank or the fasteners.
GRA
VI
TY
GRA
VI
TY
GRA
VI
TY
Figure 8:
Standard mounting
Page 9
ENDO-CVT Instructions V1.
2
AccuAir Suspension 2018