A. Daily operation of machine.
1. Make sure main air regulator reads between 90-100 PSI (main air regulator is on the side
of the machine)
2. Turn the main power switch on (front panel) Make sure the “H2O-
Run-Glue” switch just below the power switch, is in the RUN position.
(H2O = Water)
3. If using glue, purge the system (as talked about on page 2) to refill
the line with glue. If you are using water you never need to purge be-
fore or after you use the machine (purge with water is only necessary if
you run out or after filling pot.)
4. Check dowel feed speed to advance the dowels to the singulator assembly if needed.
YOU ARE NOW READY TO INSERT DOWELS!!
5. After each use of the machine you will need to flush the glue back out of the line. To do
this, hold the gun over the purge bucket, flip the switch to the H20 side and you should start
to see water come out of the gun in 7-10 seconds. Let it run a bit before you flip the switch
back to run.
6. After this you must clean off the nozzle, and any excess glue to keep it from drying and
causing problems the next time you use the machine. Return gun to holster.
Operating Procedures
