D. Set up pressure pot
There are different directions for Conventional Doweling & Pre-glued Dowels.
Follow the directions for the procedure you are using.
CONVENTIONAL DOWELING WITH GLUE
RECOMMENDED GLUE:
Franklin Assembly 161 or Tightbond doweling glue L.V. See spec. sheet in the back of this manual.
1. Remove the pressure pot from the back of the machine.
2. Open the pot and you should see a sample of glue, a plastic one gallon container, and two pick up
hoses with filters. The black tube is the glue pick up tube, and the clear tube is the water pick up tube.
The sample glue will not go too far, so make sure you have at least 5 gallons of the recommended on
hand. Always shake or stir the glue before putting it into the container.
3. Place the glue into the plastic one gallon container, place it into the middle of the pressure pot.
4. Pour water around the pot to about half full. Place the top over the pot and make sure the black
hose goes into the glue, and clear tube goes into the water.
5. Tighten the pot lid down in an even fashion. Turn the regulator up to around 30-40 PSI.
6. Go to the front of the machine and take the gun from the holster and aim it into a purge bucket
(something to contain the fluid).
