3075-GS ZOOM STEREO MICROSCOPE ON GEM STAND
ACCU-SCOPE
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
11
REPLACING THE LAMPS
(continued)
Replacing the Fluorescent Lamp in the
Top Illuminator (Fig. 12)
The fluorescent lamp in the overhead light uses
one 7 watt fluorescent lamp –
CAT #14120.
To replace the lamp, disconnect the overhead
light from the stage of the GEM stand base (see
page 8).
Remove the cover plate of the lamp housing by
unscrewing the four screws on each corner of
the cover plate using the Phillips head
screwdriver that was included with your Gem
stand.
The fluorescent lamp is connected to a socket in
the housing by a four pin connector. The socket
is held in place with a screw. Remove the screw
from the lamp socket.
Carefully pull the fluorescent lamp out from the
socket by the base of the lamp to avoid
accidental breakage.
Insert the new lamp into the socket and replace
the lamp socket screw -- be sure the lamp is
securely in before replacing the cover plate on
the lamp housing.
Once the lamp housing is reassembled, reattach
the overhead fluorescent light to the stage of the
GEM stand base (see page 8).
Fig. 11
Fig. 12
Cover plate screws
