18
___________________________________________________
FUNCTION
KEY
Pressure and release:
from main view allows the display of the
probe values configured (temperatures /
pressure in the upper display and the
corresponding one label in the lower
display.
Pressure and release in programming:
allows scrolling of folders
parameters (ST, CF, etc);
allows it scrolling through
the list of parameters.
Pressure and release:
from main view allows
the display of the probe values configured
(temperatures / pressures) in the upper
display and the label corresponding
in the lower display.
Pressure and release:
allows you to turn on the machine
(in chiller or heat pump)
or select stand-by mode.
Pressure and release:
allows you to turn on the machine
(in chiller or heat pump)
or select stand-by mode.
Pressure and release:
allows access to the function menu.
Pressure 3 seconds and release:
allows you to adjust the clock in the
models in which it is intended. Pressure
and release in programming:
lets go out from parameter modification
Simultaneous pressure of the keys
for 3 seconds:
allows access to programming
of the parameters.
Simultaneous pressure of the keys:
1 allows exit from parameter
programming.
2 contemporary pressure prolonged
keys allows entry into manual defrost.
Regarding the use of the remote terminal (indications on the
display and meaning of the keys) do reference to the preceding
paragraphs In air / air units, in case of terminal use remote
equipped with NTC probe (VICXS610),
configuring par. CF35 = 2 the display will show the room air
temperature; this probe will be used from the controller for
temperature control. In case of controller / remote terminal failure
or error in the wiring, the lack of communication between the
instrument and the remote terminal will be signaled to display
with the error message “noL” (no link).
5.4 ACCESS TO PARAMETERS
1 Press the SET and arrow keys for a few seconds downward;
2 The icons flash
and the display upper displays
“ALL” (generic group of parameters);
3 Scroll through the parameter groups with the and keys select
the group containing the parameters to access the list of
parameters contained in the group.
The lower display shows the label of the parameter and the
upper display shows the value.
5.5 DISPLAY AND MODIFY THE SET POINT
Pressing and releasing the SET key allows the display of the set
point.
The prolonged pressing of the SET key allows the its modification
1 Press the SET button for at least 3 seconds;
2 The set point will be displayed flashing;
3 To change the value, use the and keys
and
4 Save the new set point by pressing the key SET or wait for
the time out time to exit from the program.
User interface
Remote terminal
