![background image](http://html1.mh-extra.com/html/accorroni/hpe-35/hpe-35_technical-information_455706014.webp)
14
7.2
LIFTING AND HANDLING
The handling must be performed by qualified personnel, properly equipped with appropriate equipment to the weight and the
encumbrance of the unit, in compliance with safety regulations of accident preventing.
When the unloading and the placement of the unit,
it is highly recommended to avoid any sudden or
violent motion in order to protect the inner
components and the frame. The units can be lifted
by mean of a forklift or, otherwise by mean of belts,
making sure to damage the lateral panels and the
cover of the unit using a structure of spacers as
shown in the drawing. In this context, it is necessary
to hook indirectly the unit to the basement but on
two steel pipes of adequate dimension that to pass
into the appropriate holes situated in the same
basement of the unit. It is important to keep the
unit horizontal during these operations.
1) Handling with forklift
under the pallet
2) Handling with forklift
under the unit using the
appropriate windows of
passing forks
3) Handling by
mean of belts
7.3
LOCATION AND MINIMUM TECHNICAL CLEARANCES
All i-HP models are designed for outdoor installations; any cover over the unit or locating near trees (even if they partially cover
the unit) has to be avoided in order to allow the air recirculation. It is advisable to realize a supporting basement, with adequate
size similar to unit foot-print. The unit vibration level is very low: it is advisable however, to fit a rigid rubber band between
basement and unit base-frame. It is also possible to install anti-vibration supports (springs or rubbers) to keep vibrations at a very
low level. An absolute care has to be taken to ensure adequate air volume to the condenser. The re-circulation of discharge air has
to be avoided; failure to observe this point will result in poor performance or activation of safety controls. For these reasons it is
necessary to observe the following clearances:
MOD.
A
B
C
D
HPE
25 /
HPE
-LT 25
1500 1000 1000 1000
i-HP 35 /
HPE
-LT 35
1500 1000 1000 1000
HPE
50F/i-HP 0250/
HPE
-LT 50
1500 1000 1000 1000
HPE
60 /
HPE
70
1500 1000 1000 1000
* The recommended minimum distance for installation, maintenance and operation.
N.B. Avoid suspended installations. If you cannot, use your common sense and follow
local regulations, and in the case of doubt, contact your authorized service center.
Front panel