Accord XPC, Installation Manual, Page: 51 / 62

45
IE1-1230-B February 2001
The Bell output and zone LEDs (No.s), activate for five seconds. The Strobe output
flashes until the test is finished.
When the keypad LEDs (No.s) have deactivated, test the zones in turn. Activate each
zone individually to verify that the corresponding LED (No.) on the keypad displays and
you hear two beeps from the keypad.
To exit test mode enter a valid code, the keypad beeps twice to confirm.
Omit Zone 6 ( )
To omit one or more zones enter a valid user code and press 6 ( ) key. Enter the zone
numbers(s) to be omitted. After five seconds the selected zones are omitted and the panel
exits from omit.
Example: To omit specific zones
• Enter a user code.
• To omit zones six, seven and eight press 6 678.
• Zone LEDs (No.s) six, seven and eight now flash.
To delete all the zones from the omit list enter a valid user code, press the 6 ( ) key
and then press the Ö key.
When the zones are omitted, set the system in the normal way. All zones will be restored
to normal (non–omitted) operation when the system is next unset.
Note: PA Silent, PA Audible and Fire type zones cannot be omitted.
Changing Codes 8 ( )
The Accord xpC can be programmed with up to eight User Codes. User 1 is assigned as
the Master User. The master user code is neccessary to programme new User Codes for
the system.
Note: User eight may be assigned as Duress via group 6 option 4.
Reprogramming Your Code
To reprogramme your code, enter it at a keypad, select the codes option by pressing 8,
select your user number and enter the new code.
The Master User Code is code 1, the Engineer Code is code 0.
Note: The engineer must change his code from day mode not programme mode.
Example: To change the master user code (Code 1) to 5678:
• Enter the Master User Code.
• Press: 8 1 5678.
• Two beeps confirm that the new code has been accepted.
• The master user code is now 5678.